Iota I-13-EM-J User Manual

Browse online or download User Manual for Power suppliers Iota I-13-EM-J. IOTA I-13-EM-J User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 5
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. CAUTION To prevent electrical shock, do not mate unit connector until installation is complete and A.C.
power is supplied to the unit.
2. CAUTION This fixture provides more than one power supply output source. To reduce the risk of electrical
shock, disconnect both normal and emergency sources by turning off the A.C. branch circuit and by discon
-
necting the unit connector.
3. CAUTION This is a sealed unit. The integral, high temperature Ni-Cad battery is not replaceable. Replace
the entire unit when necessary and recycle or dispose of the nickel-cadmium battery properly.
4. DO NOT USE OUTDOORS. The I-13-EM-J is for use with grounded, UL Listed, damp location rated, indoor
fixtures. Not for use in heated air outlets or hazardous locations.
5. The I-13-EM-J requires an unswitched A.C. power source of either 120 or 277 volts. Properly cap the unused
A.C. lead.
6.
The I-13-EM-J and A.C. ballast must be on the same branch circuit.
7. Do not mount near gas or electric heaters.
8. The I-13-EM-J should be mounted in locations and at heights where it will not readily be subjected to tamper-
ing by unauthorized personnel.
9. The I-13-EM-J will cold strike and operate one 5W, 7W, or 9W, twin tube, double twin tube, 180ma or 13W twin
tube, double twin tube, 285ma fluorescent lamp, each with a single lampholder per lamp.
10. The I-13-EM-J is for use with fluorescent downlight fixtures.
11. Suitable for use in damp locations.
12. For use in 0° C minimum, 50° C maximum ambient temperatures.
13. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition, void
warranty, and result in non-compliance with UL specifications.
14. Do not use this equipment for other than intended use.
15. Install in accordance with the National Electrical Code and local regulations.
16. Installation and servicing should be performed by qualified personnel.
SAVE THESE INSTRUCTIONS
I-13-EM-J
INSTRUCTION MANUAL
SERIES D
COMPACT LAMP
EMERGENCY
LIGHTING EQUIPMENT
P.O. BOX 11846 TUCSON, AZ 85734
(520) 294-3292 FAX (520) 741-2837
www.iotaengineering.com
Page view 0
1 2 3 4 5

Summary of Contents

Page 1 - I-13-EM-J

IMPORTANT SAFEGUARDSWhen using electrical equipment, basic safety precautions should always be followed, including the following:READ AND FOLLOW ALL S

Page 2 - INSTALLATION INSTRUCTIONS

Page 2INSTALLATION INSTRUCTIONSCAUTION: Before installing, make certain the A.C. power is off and the I-13-EM-J unit connector is disconnected.1.

Page 3 - OPERATION

Page 3OPERATIONGeneral – This unit is primarily designed to be used with compact fluorescent lamp downlight fixtures. It will wire in con-junction with

Page 4 - TYPICAL WIRING DIAGRAMS

Page 4UNITCONNECTORCHARGEINDICATORTESTSWITCHWHITERED ORRED/BLK (+)WHT/BLKFLEXBLK (120V)ORG (277V)WHITEWHT/BLKBLUE/WHTBLUEYELLOWYEL/BLKBLUEBLACKUNSWITC

Page 5

Page 5UNITCONNECTORCHARGEINDICATORTESTSWITCHWHITERED ORRED/BLK (+)WHT/BLKWHT/BLKWHT/REDWHT/BLKFLEXBLK (120V)ORG (277V)WHITEWHT/BLKBLUE/WHTBLUEYELLOWYE

Comments to this Manuals

No comments